Question about Honda VT 1100 C Shadow Motorcycles
...rear cylinder This is a 1987 VT1100 that is only firing on the front cylinder. The carbs were pulled & cleaned, spark tested. The bike will only run on full choke and the rear cylinder will ...
Question about Honda VT 1100 C Shadow Motorcycles
...before we tried to get it to run. With fresh gas we cranked it and it ran but would not idle. The rear tire was shot and it sat up for another couple of weeks while I got the tire replaced. Now it ...
...cylinder casing. Remove left rear crankcase cover. Remove cap from the bleeder valve on the slave cylinder Put a box end wrench on the bleed valve then put a clear hose on the nipple and immerse the ...
...to clean the pumps electric contacts on the top of fuel pump, the pump is on the right site behind rear ...
Question about Honda VT 1100 C Shadow Motorcycles
...rear coil power wires at ICU. At idle both show a similar and standard ignition coil wave form, but as you come up in the RPM the signal for the front cylinder coil flattens out and miss corresponds. ...
Question about Harley Davidson Motorcycles
...rear cylinder quits how ever at above 1700 rpms it runs fine but sputers from time to time on rear cylinder at the same timerear cylinder is runing allot hoter thean front olso the plug in back is ...
rear cylinder pops and backfires, sometimes the rear cylinder will backfire after the engine is turned off, what can i do to fix this. That could be the spark plugs causing the run on. The rear piston
rear cylinder is cold, unlike the hot exhaust coming from the front running cylinder. I am getting spark to the rear cylinder. Also swapped spark plugs, with no changes. Need Help. check the cam lobes
Question about Honda VT 1100 C Shadow Motorcycles
rear cylinder is not firing then you need to perform a compression test on the rear cylinder. If it is not with in specifications, you may have broken rings, burned valves or hole in piston. Until you
Question about Honda VT 1100 C Shadow Motorcycles
...rear cylinder has good compression? Did you check the two cylinders with a compression gage? The compression should be within 10% of each other. Check the ignition timing of the rear cylinder. I will ...
177 questions posted
Usually answered in minutes!
65 Questions
50 Questions
47 Questions
33 Questions
28 Questions