...rear wheel in gear . If this does not work and it will not kick start without the spark plug out and still remain seized i am afraid that you will need to look at getting a new top end rebuilt . Give ...
Question about Honda XR 600 R Motorcycles
rear axle nut on my harley Harley manual says 60-65 ft lbs... do NOT exceed this or wheel could seize 60-65 ft/lbs when putting axle back in though make sure you use a generous amount of anti seize on
Question about Honda XR 600 R Motorcycles
...end is locked up i'm not sure could the piston of just seized up or what? Remove the spark plug, put the bike in fourth or fifth gear then try a jump start but with the key turned off. If the rear ...
...rear was seized up. I removed the brake drum with a bit of difficulty due to the seizure, cleaned everything, lubed the little pivot gear that spreads the drum shoes open, put new shoes on and ...
...rear axle. Is it seized in or is there something I can't see? This bike has been sitting for a long time and I think the axle is maybe rusted in. I can't beat it out and I can't push it out with a ...
Question about Honda XR 600 R Motorcycles
rear fender of my VStar 650 Classic that holds down the passenger seat, how do I replace it? Was it seized in place or did you over-tighten it? If you cannot access the other end of the bolt with vise
...rear wheel by hands ,kick start ,take spark plugs out spray your cylinders with vallvoline EGR valve spray ,or CRCor wd-40 or Degreaser Heavy Duty longer you don't fit the spark ...
...rear fork, rotate the axle so that the flat on the threaded end is topside and with the adjuster cam section forward, install the adjuster cam on the right end of the axle, apply a light coat of ...
...end and pivot the shock to align the bolt and the hole in the rear fork. Then tighten the shock bolt with the Snap-on adapter and since the adapter is not going to be at 90 degrees to the torque ...
...try to either roll it, or jack the back end up and try turning the rear wheel by hand. If it doesn't break loose, you may want to go ahead and take it to the shop before you scar the cylinder
22 questions posted
Usually answered in minutes!
37 Questions
17 Questions
14 Questions
9 Questions
8 Questions