2000 Harley Davidson FLHR-FLHRI Road king "start switch problems" Questions

...start switch or ignition switch a few times to get it to start especially when its colld out i played with relays under the seat sometimes it works. Thanks to anyone who knows i was told it was the ...

...start switch. Do not suspect this unless you hear the fuel pump running as this switch is linked to the fuel pump. These have a tendency to go leaky making the starter run by itself. They can also go ...

...switch then bike started. Battery was bad. Put new battery in rode for a week no problems, even had it to HD for oil change, inspection. then yesterday problem came back. push starter button and ...

...switch off and then back on unit will start and run for about 3or 4 min. When unit dies again cut switch off and back on unit will start again. sounds like a fuel filter or fuel restriction

start the engine again and drove home (no GPS connected) and had no problems anymore. A fiew months ago I had a similair problem putting the bike out the garage ready to leave for a trip, I had to try

...switch. Start off by making sure the front brake master cylinder assembly is tight against the throttle assembly switch housing. Loosen the bolts that hold either the master cylinder or the throttle ...

1999 Road King. After sitting over winter, finally got started, Idles fine but stalls letting out clutch.? Drained tank and put in clean gas. Any thoughts? If you have a side stand switch, that may ...

switch and start button. Have replaced Bank Angle Sensor, Cam Sensor, and had wiring work done, but it still does this. Help. chec wiring-there are some flaws--computer may have issues--scan bike with

...switch in DC VOLTS, 20 VOLT range. Start the engine and bring it to a high idle. Your meter should show a slow build up of voltage over about a thirty second period of time. It should read 14.5-15.0 ...