...car is citroen xara vts my brake feels very tight and my car get trouble to move.its feels like the brakes are titning up,i leave it for a bit and the brakes gos fine The servo might need adjustment, ...
...the pads contact the disc. You don't want WD on your pads for obvious reasons. Hi if you want the brakes to work correctley you will need to do the following disconnect the banjo bolt which feeds ...
my 2008 hyosung gt250r will not start but i can push it off and it works great and shifts fine and the lights go dim when the bike is not running and the brake light and head lights work but the ...
Question about Hyosung GT 250 Motorcycles
2003 Suzuki VL 1500 Intruder LC REAR DISC RATTLE,HOW DO I REPLACE IT? THE REAR BRAKE DISC HAS 8 VIBRATION BUSHINGS THAT ARE LOUSE. Hello Dale, this is an easy job on your bike. Use a flat head screw ...
...types of brake fluid, they are not compatible. Once you fill the reservoir, you must bleed the brakes. To bleed the brakes, you perform the following steps in this exact order. First, slowly ...
Question about Hyosung GT 250 Motorcycles
i took the front wheel off and now i have no brake pressure in front brake the brake just will not pump up if you disconnected the brake line you need to bleed the brake system you have air in the ...
rear brake light will not work when brake pedal is applied, both front and rear brakes run through same sensor front brake applies rear light, but rear brake pedal doesnt. where is the problem? It ...
Question about Hyosung GT 250 Motorcycles
...the master cylinder relief port because a plugged or otherwise blocked relief port could cause the brakes to drag or stick on. Do this by pressing against the rear brake caliper to push the caliper ...
2008 fxstc harley brake light stays on. I changed the front brake light switch but still stays on. Any help? Check the rear brake light pressure switch. Follow the metal tube that comes out of the ...
...the stock brake line or the pads that are the main problem, or something else? Cheers, Hi, spongy brakes is usually from air in the system, only in really old bikes and poor quality brake lines
110 questions posted
Usually answered in minutes!
5 Questions
2 Questions
0 Questions
2 Questions
1 Questions