Husqvarna 445 starts and stops running check carb settings. turn low speed adjusting screw all the way in then turn it out about 1 1/4 turns out. repeat with high speed screw. when running readjust ...
need intructions on carberator adjustments for mac-3514 35cc/cm3 runs but hard to start after using it for few minutes. There is a low speed jet and high speed. Low speed sets the idle or stays ...
...run at top speed First dump out the old gas and put in fresh gas.If no fix rock both the high and low needle valves 1/4 turn each way and then return them to the original setting. Start the saw and ...
...And low Basic rule of thumb is 1 turn out on the high and 1/2 turn on low. This should get machine running then you fine tune while engine is ...
run away high rives Idle screw backed out all the way, throtle is closed, air cleaner is clean. Engine still runs away at very , very high RPM. so high of RPM the kill switch won't shut it off. I used
...run in high idle The chain saw starts and will run fine on low idle, but when I attempt to run it in high idle it shuts down. I have never been able to use the saw. Have tried to adjust the idle but ...
...opening one turn each. Set the idle speed up or down to make it idle to the point where chain just stops moving. Set high speed to where it will run full throttle smoothly Hope this helps. Thank ...
...screws turned in. adjust the high screw to 1 turn and the low to 1/2 turn. this should get unit running. once running then you can fine tune the ...
high and low adjustment screws;however the cover over the carb. seems to have an effect before and after adjustments are made to the general performance of the way she runs once warmed up. my question
Question about Garden
Run the engine at full speed and adjust the high screw. Let off the trigger and adjust the low screw. Once the mixture screws are adjusted, you can turn the idle screw to adjust the idle speed. It can
540 questions posted
Usually answered in minutes!
529 Questions
473 Questions
353 Questions
122 Questions
131 Questions