Remington 16" Electric Chain Saw Assembled 3.0 Peak "cut runs slow" Questions

runs fine and doesn not slow down. I checked the oil, cleared the oil vents to the chain, the brake is fine and is not causing the problem. The chain is new and is tight but not too tight. The wood is

...cut off any idea what the problem might be It certainly sounds fuel related, remove the fuel hose from the fuel tank and replace the filter on the end, try the machine again, if it is no better it ...

...runs slow/ chain too tight? ryobi 540A need manual. Saw runs slow/ chain too tight? Had for 2 years, not used, lost book, didn't want to harm saw, or have to change blade without instructions. Lost ...

...runs smooth without chain moving....if to slow the motor will stop....for fast screw....rev motor flat out then adjust so it screams its head off so to speak....it will need all its power for cutting ...

...runs smooth without chain moving....if to slow the motor will stop....for fast screw....rev motor flat out then adjust so it screams its head off so to speak....it will need all its power for cutting ...

runs fine but the blade slows down to stop when i cut husqavarna too much load (too large a cut), dull chain, no lubrication oil on chain, slipping clutch.. lots of reasons.. need more information and

My Stihl 028WB chainsaw will start and run a little, will cut for a short time but then the chain slows down and no matter if I hold the throttle wide open it will not cut fast and basically won't cut

My chainsaw 42 cc poulan chainsaw will run and cut good for about 10 minutes then will start slowing down and quit I have replaced all fuel lines and new Carburetor as well Pull and check the cylinder

...runs then slows down... recharge battery and will cut one board maybe...looks like electrical brake is trying to stop blade and run battery down..how can i disable or fix?? If it is more than a year ...

...cut through 2 inch piece of wood. It does not stall, the chain just stops moving, and the engine seems to slow down as if it has a clutch that's giving out. Is this merely the result of a dull blade? ...