Question about Coleman Electrical Supplies
...gas from . ... ...starts and runs fine for about a minute, then dies as though starved for fuel. ... load up on fullchoke and stay running around 3/4 choke HI, Turn off the gas and take ... Generator ...
Question about Coleman Electrical Supplies
...starts fine and runs on choke but not off choke it cranks immediately; new gas, full oil. warms up nicely on choke, but the minute we take it off choke, it starts to sputter and dies. Every time. It ...
runs with the choke position and when I move the choke lever to run it stops running. It has to be on choke to run. There is an air leak in the seals somewhere between the carb and the intake manifold
Question about Generac Power Systems Electrical Supplies
...gas generator (should the choke be in or out, to the right or the left before starting Most Generac generators have a lever for the choke that pulls out. So if the generator is being started for the ...
Question about Powermate Electrical Supplies
runs for hours under the same a mount of load then, chokes down, make sure fuel lines are fully clear, it may operate with a full tank of gas then when the weight of the fuel in the tank gets less has
Question about Northstar Electrical Supplies
...gas will run out fine if you try to start it with in 15-30 mins it will start right away Sounds like the choke is not closing. Perhaps it has become detached from the manual throttle. A simple test ...
...starts on choke and will only run if I leave the choke on. What would be the problem Chokes are used to draw gas through the center jet to run. If the choke is not working properly and it is not ...
starts with choke on however as soon as i start closing the choke generator shuts down, any ideal on how to correct Get a can of carburetor cleaner. Drain the gas. Mix small quantity of fresh gas &
Question about Coleman Electrical Supplies
...manual for the 5500 gas generator i have a coleman powermate 5500 with yamahe engine starts fine but has no power reset buttons did not pop and i replaced the brushes any help would greatly ...
...choke HI, Turn off the gas and take the bowl off the carburetor.Look for water bubbles in the gas that spills away. Water will float like little balls on gas. If so drain gas tank put in new gas with ...
53 questions posted
Usually answered in minutes!
1 Questions
