Goldstar DH304 Dehumidifier "multimeter" Questions

...for testing. How To Test the Compressor Relay Test the compressor relay for continuity using a multimeter . Set the multimeter to the ohms setting X1. With the relay upside down, place the

...on. It could be the switch itself, or the power cord, or some internal component. If you have a multimeter, you can take the unit apart and test the switch and the power cord. Also make sure the ...

Indicator says "tank full" Had been bypassing tank with hose. Crack in hose required replacing. Changed hose by using standard washer hose. Now I get "tank full" message. Nothing else been changed. ...

...tape was still securing the filter and the water bin lid...I’m pretty mExhanical and can read a multimeter. I’d appreciate any help. I’m also using a friends Frigidaire and his blower is ...

...which may require the help of Whirlpool Technical Service to solve. That is, unless you have a multimeter and want to dismantle the unit to find the electrical problem. Could simply be a shorted ...

...straight screwdriver and carefully pop the tabs open to remove the front cover. You can test with a multimeter set to ohms and check if the POT is good. I used some electronics cleaner spray and ...

...will prevent the dehumidifier from running. To determine if the bucket switch is defective, use a multimeter to test it for continuity. If the bucket switch does not have continuity, replace it. ...

...sleeve as the incoming wires connect to the motor windings. A fuse is easy to test using any multimeter a good fuse will show continuity and a dead fuse will show... nothing (open circuit) You ...

...power button and the display but it did not fix the problem. What tests do you suggest? I have a multimeter. I assume that the capacitor is there to start the motor so I did not discharge nor test ...