Jl Audio 1000/1 Car Audio Amplifier "100hz" Questions

...x 4 4 ohm bridged @ 13.8 VDC 150 WRMS x 2 Crossover Frequencies 20Hz to 20kHz(Rnet factory set at 100Hz) Crossover Slopes 24dB per ...

...tuning recommendations with the ac multimeter. I'm also running an external active crossover set to 100hz and a 500k microfarad cap. The amp is running 2 mtx jackhammer 12's. The subs are hitting, ...

...your subwoofer. Your Kenwood is 500W x 1 at 4ohms [20-200kHz 0.5% THD] 900W x 1 at 2ohms [100Hz 1.1% THD] Your L7 is: Max Rec Amplifier Power (WATTS PEAK/RMS)* 2000/1000But its ok for your ...

...Switch to LPF. Turn the Bass Gain/ level all the way down temporarily. Set your Crossover to below 100HZ. Then Turn on the system with a Bass test sound. Turn up your bass Gain/level until you get ...

...the crossover and gains for the best output to subs. LP filter on, crossover frequency at about 80-100Hz, and gain to maximum without distortion when head unit volume is at about 3/4 maximum. Hope ...

...-12 slope , it should work fine. Cut-off frequency: 50HZ - 63HZ - 80HZ same as kicker cut in freq - 100HZ - 125HZ - 160HZ - 200HZ Output level: - 24 to +6 Slope level: - 6 - - 12 ...

...unit to both amp inputs. The switch marked "LPF" should be "ON" and the crossover set to about

)). Now dial in amp: turn up a bit probably to 1/4 or so then tune frequency I'd usually say around 100hz, then adjust gain again to where it sounds good...be easy on them for awhile to let them break

...sub, the high pass filter should be off, the low pass filter on, and the crossover set to around 80-100Hz. Even then, I would not expect very much bass. 50 watts per channel at 4ohms or 75 watts per ...

...freq setting on the amp, maybe it has been turned too low e.g. turn up to freq level around 80-100hz. check the phasing of the sub speaker connections. if they connected out of phase you will