2008 Toyota RAV4 "remove taillight" Questions

...taillight assembly on 2007 RAV 4 will I need to remove inner body panels, and if so do I need special tools? remove your tail light lens assembly using a screw driver slide the lens and lift it off ...

under the tail light) emove this screw and panel, thjis will expose two screws holding the tail light assembly, remove these screws and the taillight assy will come loose , now you can remove the lamp

...remove it from taillight housing. (5) remove the bulb from the connector socket and install replacement bulb. (6) install the bulb and connector assembly into the taillight housing and rotate the ...

remove the taillight bulbs through the trunk. Usually you can access the taillight through the trunk. Sometimes you just need to undo a few bolts and sometimes you don't even have to. Most of the time

...Remove the wire assembly from the taillight, replace the bulb and put it back into the taillight. SLide the taillight assembly back in place, but the three bolts back on, snap the trunk skin into ...

...remove the taillight assembly. See diagram in section 7 of your manual to figure out which bulbs to replace if needed. !!!Don't touch the bulb socket unless you're sure the car's ...

...screws that hold the taillight to the rear panel of the car that have to come off from the inside of the trunk. Remove the nuts and screws, then remove the taillight. hope that answers your ...

...the bed behind the tail light remove them and remove two nuts holding taillight in now put tape around the taillight on the body and pry around the taillight with a screwdriver till it comes ...

remove the taillight from the car now on the outside you should be able to access the bulbs from there by turning the bulb plugs about a 1/4 to a 1/2 turn, reassemble the taillight and interior panels

...remove rear taillight to get at the rear marker light. i removed the two screws but the taillight doesn't want to come out. i don't want to break it. Try and see if you can get access to the ...