1992 Toyota Celica "radio pin" Questions

reset radio with speakers disconnected or connected back to working order some radios have terminal pin locations stcker on side of radio or stamped on it if not sure where wires go to what terminals

...radio and put it back in. Once I put it back in the cd player worked just fine! cds stuck in car stereo- error message pops up, advice? I have a 2003 Toyota Tundra with a 6 disk CD player, factory ...

...pin 19 Radio Ground (chassis, base audio); black/white (except base audio) - radio, white 20 pin plug, pin 20 Radio Ignition blue + radio, white 20 pin plug, pin 7 Radio Illumination lt. green ...

pin 1 Radio Ground black/white - radio, black 14 pin plug, pin 8 Radio Ignition (low speed GMLAN) Radio Illumination yellow (dimmer) + radio, black 14 pin plug, pin 7 Left Front Speaker (+/-) dk. blue

...radio with the 16 pin connector the your power wires are pin # 7 a yellow with a green tracer wire and pin # 16 an orange with a black tracer. Your ground will be pin # 8 a black with a green tracer ...

...Radio--KEX-M8406zt, manufactory-Pioneer and is a TOYOTA 86120-3A522 Lexus Premium Sound system. It has two connectors. One is a 20 pin, starting top roll on the left Pin 1 no wire, pin 2-Black wire, ...

...radio pin nembers pin, ? as in electrical pin numbers. or as in P.I.N, as in personal id number? that is a password . if a P.I.N , this is set by the last owner, not the factory the car came with no ...

...pin to radio on vt commodore , but vehicle will not accept it there could be a couple of reason why it wont accept the radio pin. Its possible that the radio pin you have is the orginal and maybe at ...

radio? If so, there are TWO power inputs to it. Yellow wire & Red wire (Y=pin 7, R= pin 16). Pin 16 is always HOT (ON), and pin 7 is ONLY HOT when the ignition key is in Accessory or Run position.

FORD RADIO CAN NOT TAKE OUT FORD RADIO..HAVE USED THE PINS BUT WILL NOT COME OUT,,,,HELP soem radios are nto just sitting in ther by pins, sometimes you have to take off te dash remove screws then ...