1996 Toyota Tercel "engine knock 2001 pontiac grand" Questions

...engine over 2000 rpm and it stops after 4000 rpm or higher, it's a 2001 Pontiac Grand Am 2.4 L. What could this possibly be? piston noise most likely Sounds like you experiencing a crank bearing ...

...knock sensor, the sensor will cause, sluggish engine, poor acceleration, poor fuel economy. the signal is sent to pcm and the timing is retarded to compensate for the severe detonition. on 4 cylinder ...

...ENGINE STARTED TICKING THEN ONE MORNING STARTED AND A LOUD KNOCK OCCURED THEN IT STOPPED FOR 2 MONTHS AND STARTED AGAINNOW SEVERAL LOUD NOISESALL KNOCKING NOISESSTILL RUNS GOOD BUT AFTER ABOUT 10 ...

knock on the bottom of the engine. I can also feel is slightly on the floor near my feet. I usually happens when I hit 40-45 mph. Sometimes it happens when I stop, between 10-0 mph. If if feels like a

engine knock pontiac cars are mainly junk (sorry but its true) especially grand am. Sounds like you threw a rod or bearing, but don't feel bad it would've happened whether or not you ran it low on oil

knock, coming from the top of the engine. It does not over-heat, and it does not burn oil, and is not blowing any smoke out of the exhaust, it just has the knock. I am hoping it is just a loose rocker

...knock sensors on this engine, one on the front (as shown), and another in the rear. There isn't one on the driver's side, per se. I recommend that you let the vehicle cool down before beginning this ...

...engine knock car started to smoke. Pull over, and sure enough busted radiator hose. Replaced hose, replaced lost coolant, and now I have a minor knocking in my engine. Please help. Its possible you ...

...gaskets for 3100 sfi motor now theres a lound knocking comeing from motor On the 3.1L engine you have to remove the push rods to replace the intake manifold gasket. It is possible that ...

knock sensor and check engine light is still on. Howbdo I fix this problem. I am unable to pass emissions. Please help!l I have been told could possibly be a bad wire?? What codes were reading for the