1997 Geo Metro "remove rear seat" Questions

...remove the rear bench seat from a 1997 Geo Metro? at the base of the seat down were the floor meets the seat check to see if there are 2 bolts one on either side of the seat about in the area of wear ...

...rear shock, put tower strut end in 1st, on the lower end there is less than a fingers width of room before the tab is flush with split knuckle? which is holding the lower end, do I need to remove the ...

remove a rear seat from a 2004 Ford Mustang Coupe? please rate highly if this is what you need Section 01-10: Seats and Tracks 1994 Mustang. Workshop Manual REMOVAL AND INSTALLATION Seat Cushion, Rear

...Remove the 40% rear seat backrest. Remove the nuts and bolts. Remove the backrest. 60% rear seat backrest Remove the 60% rear seat backrest. Remove the nut and bolt. Remove the backrest. Installation ...

Remove the two rear seat bolts from the front of the rear seat cushion latch cover. Lift the rear seat cushion floor cover on the back of the rear bench seat and remove the two inboard rear seat bolts

...Remove rear seat cushion. Refer to Section 01-10 . Seat Cushion, Rear Sedan Removal Apply knee pressure to lower front portion of the rear seat cushion. Push rearward to disengage rear seat cushion ...

...Remove the rear seat. Refer to Rear Seat Replacement. Remove the left quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement. Preliminary Procedure Remove the rear compartment ...

...Remove rear seat back by tilting forward and pulling straight up. To install: Install the lower seat cushion and torque the lower rear seat-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm). Install the ...

remove the rear seat on 1196 honda accord? The rear seat is four (4) pieces. You will need two tools a 6mm and 8mm wrenches. 1.) Unbuckle the rear seat belts. 2.) Locate the bolt in the center part of

...Remove rear seat back by tilting forward and pulling straight up. To install: Install the lower seat cushion and torque the lower rear seat-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm). Install the ...