Question about Jeep Grand Cherokee
changed battery, lights work etc, door's open and close, but will not start engine. what do I do next? check all the fuses, connections, wires than id go directly to checking for a spark, fuel and ...
state of rapid cycling, the PCM will use a fixed time interval to cycle the solenoid. The Charcoal Canister EVAP/Purge Solenoid: The duty cycle EVAP canister purge solenoid (DCP) regulates the rate of
state of rapid cycling, the PCM will use a fixed time interval to cycle the solenoid. The Charcoal Canister EVAP/Purge Solenoid: The duty cycle EVAP canister purge solenoid (DCP) regulates the rate of
...state, the tighter the evaporative system is sealed. If the system pressurizes too quickly, a restriction somewhere in the EVAP system may be indicated. Diaphragm Upward Movement When the PCM ...
idles rough,run ok at road speed misses occasionally changed plugs,wires,cap,rotor button,cleaned throttle body,changed idle air,throttle position sensor This one is tricky. Any check engine lights. ...
Question about Jeep Grand Cherokee
Why does the engine show a misfire but runs perfectly fine. After driving a few minutes it will turn on the check engine light. Everything else has check and rechecked and have found nothing wrong wit
Center dash lights out. The three knobs in the center that control the heat are not eluminated. I'm tired of turning the overhead dash light to see were the airflow vent is blowing at night. Is there ...
...connected, the fan relay is the most likely problem. 3. If fan operates but a high current draw is suspected continue with the following ammeter TESTING. 4. Disconnect the electrical connector from ...
Question about Jeep Grand Cherokee
...connected by serial data circuits, one module is the power mode master (PMM). On this vehicle the PMM is the Body Control Module (BCM). The BCM receives 2 signals/circuits from the ignition switch. ...
Question about Buick Cars & Trucks
...connected by serial data circuits, one module is the power mode master (PMM). On this vehicle the PMM is the Body Control Module (BCM). The BCM receives 4 signals/circuits from the ignition switch. ...
3,787 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,715 Questions
2,521 Questions
2,639 Questions