1995 Jeep Grand Cherokee "amp clip" Questions

Ad

Question about Jeep Grand Cherokee

1 Answer

how do you change the driver side low beam headlight its easy open ur car bonit & c if there is battry there ,then lose ur battry clips & make some space for heand & then first pull ur ...

Ad

...they attach. Slide up clips or down depending on which end. Pry between end of shaft & ball post. They will pop off. Repeat on both ends. New ones just pop on & slide clip to hold in

Ad

Question about Jeep Grand Cherokee

1 Answer

...detached with a plastic clip on it....what to do? 2002 jeep grand cherokee You need to go to auto parts store & get new clips. HELP/Motormite sells them in pairs. Attach clip then attach

Question about Jeep Grand Cherokee

1 Answer

...with the car stereo, when switched on it starts to give an error (amp clip) which i cannot understand, check that the wiring to the amp underneath the right hand side back seat have not been ...

...clip and remove the line. with a wrench between 1/2" & 3/4" . Make sure you have a drain bucket underneath. You may want to remove the coolant. You can go to autozone.com and register for full ...

Question about Jeep Grand Cherokee

1 Answer

...down. It does weight a lot. For the radio, I have the infitiy gold system and that comes with an amplifier from factory. That amp sits underneath the left rear passenger seat. In my vehicle that ...

...that comes with an o-ring to be sure it's not the injector itself. Fuel Injector - for V8 REMOVAL & INSTALLATION Before servicing the vehicle, refer to the precautions in the beginning of this ...

Question about Jeep Grand Cherokee

2 Answers

...amp engine control module fuse blows cant find any bad wires what else will cause this fuse to blow use a circuit breaker or paper clip with pliers so you do not burn yourself use paper clip as fuse ...

Question about Jeep Grand Cherokee

1 Answer

How to Replace rear plastic bumber How to remove & Replace new rear plastic bumber There are plastic rivets taht need to be pull and possibly to be cut. and there should have 2-3 bolts per side ...

Question about Jeep Grand Cherokee

1 Answer

...amp; how to remove 3 wire connector from it. Connector has a release clip on it. Part itself is held on by two torx screws. Keep the new part straight and make sure it engages the throttle shaft when ...

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

3,784 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...