1988 Chrysler LeBaron "test crank position sensor" Questions

Ad

...test. If the battery voltage is not at least 12.4 volts, refer to Section 1 for battery charging procedures. Crank the engine for 5 seconds while monitoring the voltage at the coil positive (+) ...

Ad

Question about Chrysler LeBaron

2 Answers

...test light to see if there are 2 hot inputs (with key on--there is only one hot with key off) to the relay at the socket. If yes, replace relay. If no, your ignition switch or wiring is bad. If you ...

Ad

...crank position sensor location test and troubleshoot. For testing crank sensor,check the help link below:---How to test Crankshaft Position Sensor? ...

Question about Chrysler LeBaron

2 Answers

...test a CRANKSHAFT POSITION SENSOR Unplug sensor connector,using a digital volt ohm meter set on ac volts position.Connect the leads to the two pins in the connector of the crank sensor.Then have a ...

...test the crank position sensor on a 1997 astro van ?The sensor is not installed on the van and I do not have access to the van right now. Also, do you know how much this part is worth.Thanks,Frank If ...

Question about Chrysler LeBaron

1 Answer

...crank position sensor. Often the cause of no spark, but could also be the ignition control module, the camshaft position sensor, or the pcm. If you want to be sure before replacing the sensor, have ...

...and also for engine timing. when a vehicle does not crank you need to look at starting system. check your battery, load test it. check for starter signal to starter solenoid from ignition

...how to test automotive sensors an electronic's ? How to Test the 3 8L GM Crank Sensor With Multimeter How To Troubleshoot No Start GM 3 8L GM 3 8L Ignition Control Module And Crank 3X 18X Sensor ...

Question about Chrysler LeBaron

2 Answers

...crank position sensor and camshaft position sensor signals out of sequence the results of the pretest smog test at 2400 rpm suggest that the cam advance solenoid or system is failing that will alter ...

Question about Chrysler LeBaron

1 Answer

crank position sensor and cam position sensor. Had the electronic ignition module tested. Tested fine. Still no spark. Fuses in interior fuse block test good. 1. Monitor the 5v reference, Gray wire to

Not finding what you are looking for?
Cars & Trucks Logo

116 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...