1999 Chrysler Sebring "crank shaft sensor" Questions

crank shaft sensor and magnet behind camshaft sensor and the check engine light came back on and car jerks when i accelerate. the darn light still comes back on and reads cam shaft sensor/ crank shaft

...crank shaft sensor the car dies and somtimes restarts going or idling Hello... If you have the 2.5 liter engine, The Crank Shaft Sensor is located near the bottom (beneath) the Distributor. Hope this ...

crank shaft position sensor Hello Daredevil. The crank shaft position sensor is mounted on the transmission. Here is a diagram, remove the parts as they are numbered to access it. If you need further ...

...on a chrysler Ware is the cam/crank shaft Pos. Correlation sensor A- Bank 1 located on a Chrysler Sebring 2002 2.0LEng. should be at the right rear of engine block just ahead of the ...

...crank shaft sensor needs replaced, but i have no idea where its located. The salesperson at the auto parts store was trying to tell me its located in the far rear of the car, as part of the exhaust ...

...told to spray starter fluid on it and it stated but it jerks when i drive it. whats wrong? Crank or cam shaft sensor fuel pump,its relay or circuit. Cam/ Crank sensor tell ECU which injector to

...crank shaft sensor and it was fine for a few days drove great now randomly sputters at low speeds before changing crank sensor it was at 65 or higher ??? its crazy its so random Should have a check ...

...get thrust bearings then you have little option but to junk the crank as a floating shaft will give you problems with timing belt/chain alignment and ignition timing along with crank sensor

...off to replace the crank shaft sensor remove battery& tray air intake tube distr cap & u may have enough room to take out sensor 1 bolt if not remove distr & mark location of rotor ...

...sebring 2.4 engine? Usually the crank shaft position sensor is located on the top of the transmission bell housing, on the back side right next to the top of the motor. Do you have a trouble