...distributor cap. Remove the distributor cap-there are two hold down screws. Mark the rotor position relative to the distributor body. Then remove the rotor. Unfasten the two electrical connections ...
Car will not start. Replaced plugs, wires, distributor cap, and rotor. Still has no spark. Check your ignition module. Are you getting power to the distributor?
...distributor V6? the cap should be marked. front cylinders are 2 4 6 rears are 1 3 5. the firing order is 1 2 3 4 5 6. Can I get a good picture of the distributor n where the front plug wires go ? My ...
spark plu wires connected incorrectly to distributor cap of 2000 chrysler cirrus is yours one of these?
Question about Chrysler Cirrus
where is the distributor cap in my 2000 chrysler cirrus 2.5l V6 On the rear face of the right cylinder head. Cam sensor is built into it too. Just follow a plug wire.
distributor cap??? since it is a 2000 there is no distributor. it sounds like you need to go to your local auto parts store and buy a fuel filter and good ol can of seafoam. your fuel injectors may be
...still miss firing on cylinder 4 and 5 . I am gonna try putting a distributor cap and rotor in it, and if that dont work any other suggestions? that should fix it,unless you have a burnt valve. hope ...
...while you hold your thumb on the plug hole. You will feel the compression stroke and can check the timing marks if visible. Then with the distributor cap off point the rotor towards number one
Question about Chrysler Cirrus
...the relay may have been changed what else could it be ???? Mike - If you have a distributor cap, the cap may be cracked. This is normally how you can tell that the cap is bad. These are the
...the consesus is to replace the distributor??? why can't I just replace the cap, and rotor.? you can do that as the problem is moisture inside the cap you can seal the lot with silicon spray as ...
361 questions posted
Usually answered in minutes!
391 Questions
244 Questions
193 Questions
168 Questions
124 Questions