...Holden Rodeo 1989 2.6mpi , start and only runs for 2 or so seconds themselves stalls, after putting on a fuel peesure gauge, fuel looked okay and slowly dropping, found the ECM relay was ...
...model holden rodeo you will find the oil filter located at the front of the engine,down the bottom .you will need to gain access from under the vehicle and there should also be a stone tray to
...Holden Rodeo which, when idling, revs very high and then very low. The high revs get progressively higher with each cycle and the low revs get progressively lower until the engine stalls. Revs can be ...
Question about Isuzu Rodeo
holden rodeo. 2.6 ltr 4ze1 engine. How do the thrust washers on the 3rd journal bearing go in and stay there? i have found the old thrust bearings in the sump and know where they should go(3rd journal
...engine with turbo and intercooler which replaced the 4JH1 in the Holden Rodeo and later Chevrolet & Holden Colorado produced in Thailand. Stock power was 146 hp (107 kW) and 294 N·m with a 17.5:1 ...
...holden rodeo speedo not working? The speedo has just stopped working. This morning when I started up it did not work. The tacho seems to be fine. Where should I start to look? sounds like the output ...
holden rodeo turbo diesel 2007 sometimes engine losses power and only reves to 1000rpm has engine light on can be started after few minuites needing diagnostic codes I KNOW SOMEONE WITH EXACT PROBLEM.
...with a 4jg2t in 96 tf rodeo. can i replace my 4bj1t engine with a 4jg2t in 96 tf holden redeo no it wont comply to emission laws and some wiring differences and a couple of minor issues are ...
...holden rodeo 3L ITD. dt P1120. Saying tps fault. Used scan tool to inspect data list an ECU is recieving signal perfect. Goes from 16% to 100%. Double checked TPS output from TPS plug and goes from ...
772 questions posted
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions
