2001 Jeep Grand Cherokee "replace coils" Questions

...coil on the coil ground circuit wire. 3. Check connections at the coil and at the PCM. 4. If good, replace the ignition coil. 5. If the problem is still there, replace the

miss fires and stots off when I give it gas as codes 1391 ,0351, 0352, 0353, P1391 - Not a valid obd code. B1391 - Oil Level Switch Circuit Failure C1391 - Not a valid obd code. U1391 - Not a valid ...

1996 jeep grand Cherokee will turn over but not start. weak spark. fuel at fuel rail. replaced PCM 1 month ago. replaced crank shaft sensor 3 months ago.... See if your getting spark at the ign. coil ...

no spart from coil If the coil has no spark, the coil pack is most likely bad. In order for you plugs to fire off, it has to receive spark from some type of coil. i have no spark to the plugs and ...

REPLACE SPARK PLUGS YOU REMOVE COIL PACK MOUNTING BOLTS THEN REMOVE THE COIL PACK WITH BOOT OVER THE SPARK PLUG.YOU HAVE 6 INDIVIDUAL COIL PACK TO EACH CYLINDER. YOU NEED A 3/8 RATCHET WRENCH - LONG 3

We have replaced the coil pack 3 times and the pcm once and about every 6 months we get a code for misfire on cylinder # 1 and winds down to replacing the coil pack every 6 months. Have seen this ...

1993 jeep cherokee. Can't get spark out of coil. 1993 jeep cherokee. Can't get spark out of coil. replaced coil..still no fire. multimeter shows no volts from coil to distributor. STUMPED Check the ...

no spark at ignition coil, changed coil, still no spark no spark at ignition coil. changed coil still no spark have the crank postion sensor replaced. i had the same problem. dealer cost about $600.00

check engine light went on, got a diagnostic. read cylander 3.. replaced spark plug. re set the light but it came back on and its burning alot of gas. coil bracket? What the plug fouled? Have you ...

...coils (on four cylinder engine they are arranged plugs 1 + 4 on one coil and plugs 2 + 3 on the other coil). Turn the engine over and sparks should jump between the terminals on the coil. If this ...