Question about Jeep Grand Cherokee
...Crank Sensor: Passenger side of transmission just to right and above the differential cover. Has 3 wires: Light Blue/Dark Blue stripe - Signal Dark Red - 8v supply Black/Light Blue stripe - Ground If ...
Question about Dodge Cars & Trucks
crank sensor, got cranks senor code. disconnected Cam sensor, got cam sensor code. ASD relay is pulling in. Power is getting to the coil pack. But no spark to the plugs and no fuel from the injectors.
...crank sensor and test it to make sure its properly working.I recommend that you allow a service station test it because all the electrical values are different from car to car.Its very possible that ...
...crank sensor and test the power to the orange wire with the ignition on the power should be 8 volts if you have that than try pluging the crank sensor back in and back probe the light and dark blue ...
Question about Jeep Grand Cherokee
...crank and cam sensors and coil still not starting sorry that was not firing on 1 and 4 What fault codes do you have in memory. You can run the test without a scanner by using this procedure at this ...
Question about Dodge Cars & Trucks
...Sensor Wiring Engine will not start. There is no spark, no fuel injector pulse and no power to the coil.... 1995 Dodge Grand Caravan 3.0L, V6, Gas, Asp N, VIN 3, 12V, SOHC, FI, USA * Test Details... ...
Question about Jeep Grand Cherokee
...Changed #3 fuel injector (per computer), crank shaft position sensor, cam shaft position sensor, smoke test shows no leaks, pressure test was fine. what is your problem.? is the truck not
Question about Jeep Grand Cherokee
test light back probe the injectors while the engine is turning over via the starter, the led should flash. check the ignition timing to make sure timing is ok. if all the above is ok it should start.
...try checking your connectors again .sounds like a bad pin at he ecm when the problem comes back test the voltage going from crank sensor to ecm . an old pinched wire will do the same off n on ...
Question about Jeep Grand Cherokee
...CRANK SIGNALS..WHEN CRANKING..HOLD YOUR TEST LIGHT ON DG/OR WIRE AT COIL AND HAVE SOMEONE JUST TURN KEY ON..YOU SHOULD GET POWER FOR 2-3 SECONDS..IF IT DOES,THE CIRCUIT TO THE COIL IS OK..CHECK ALL ...
4,475 questions posted
Usually answered in minutes!
3,350 Questions
2,899 Questions
2,715 Questions
2,521 Questions
2,639 Questions