2000 Ford Excursion "replace temp actuator door 2002" Questions

Ad

...temp in LOW possition and Cold when in HOT. WHAT did I do wrong and can I fix without DASH/HVAC removal AGAIN? never done one ?? but from what you describe you have fitted an actuator arm back to ...

Ad

...looks like the picture below. Let me know if you have more questions. the temp door may be stuck, or the actuator motor is bad. I woul dhave ashop look at it, some of these are a big job to

Ad

Question about Ford Excursion

2 Answers

temp should reach appx. 40 degrees..hope this helps..chris Was browsing the ford f-150 forum and found that Ford has a lot of issues with it's AC, some too hot and some like yours, way to cold. At MAX

Question about Ford Excursion

3 Answers

...caused in most cases by the air temp control blend door actuator being defective. your blend door is not working. hope this help its a3100 motor replace the intake gaskets leaking coolant in to ...

temp to cold. Then you probably need a temperature blend door actuator. I replaced one this morning. Not a easy job to do. The shop manual says the entire dash has to come out to replace the actuator.

Question about Ford Excursion

3 Answers

...temp blend door in the heater case. or the servo motor is broken. this sits on top of the heater case Check blend door operation pull glove compartment box out remove blend door actuator actuator and ...

...on Highest setting only. approx. 150,000 miles on car. The temp door actuator motor is not working on the blower box,the dash will have to be pulled out toward the seats to access the actuator

...temp doors and these are controlled by actuators. Some times they go haywire. First thing you should do is unhook the battery for a minute. When you start it back up the door actuators will go thru a ...

...temp actuator. Located in the center of the dash on the bottom, you have to remove the hush panel on the rh side of the truck were the a/c blend door is located in 2002 chevy silverado In addition to ...

...temp control knob to the warm temperature. The air continues to blow with no pressure decrease but the air never warms up. bad actuator in dash Sounds like you have a bad blend door motor.The plastic ...

Not finding what you are looking for?
2000 Ford Excursion Logo

532 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...