20 Most Recent
2000 Ford Excursion Questions & Answers
My ford v10 engines hesitates under load. It
1 Ignition system not operating properly
2 Dirtyor clogged fuel injector(s).
3 Low fuel pressure. Check for proper operation of the fuel pump and for restrictions in the fuel filter and lines.
4 Fuel injectionor engine control systems malfunction.
5 Vacuum leak at the intake manifold or vacuum hoses.
6 Restricted air filter.
7 Fuel pump or pressure regulator defective.
1/17/2022 1:34:35 PM •
2000 Ford...
•
Answered
on Jan 17, 2022
Need fuse relay diagram for ford excursion 2000 v10 4wd
Him trying to put the batterie cables on the batterie to charge it because it's dead but at same time the horn goes on then I take the cable off the the batterie it shuts off nd I wanna know where is the fuse at to remove it but my fuse box dnt have a cover on it so I cant tell which fuse it is
1/5/2020 8:33:22 PM •
2000 Ford...
•
Answered
on Jan 05, 2020
Trouble code indicates all four glow plug on the left side bad
The garage should be able to test the glow plugs without removing them. All the need to do is use an ammeter or amp clamp and measure the current drawn by the glow plugs. the glow plugs should draw 16 - 20 amps each. much less than that and they want replacing.
11/9/2017 2:30:02 PM •
2000 Ford...
•
Answered
on Nov 09, 2017
Why can't I start?
If the speedometer works and odometer doesn't it is mostly chip failure. Ford put the security in the cluster also. For a few years. Replace the cluster. You also have to have the system reprogrammed.
4/12/2016 12:00:10 AM •
2000 Ford...
•
Answered
on Apr 12, 2016
How to remove fuel filter on a 2001 f250 v10 gas truck
I just purchased a 1999 F-250 Super Duty with the V-10 engine. It was running rough, so I took a chance on some after-market coils. I bought a set of 10 for just over $75.00 shipped (for all 10 total!!!). They came with new boots, too. They smoothed out the engine just fine and, of course, increased my fuel mileage, too. There ARE reasonably priced parts out there if you shop around.
3/22/2016 5:31:06 AM •
2000 Ford...
•
Answered
on Mar 22, 2016
What parts do i need for a tune up
if it is an EFI engine then the parts that you will need for a tune up will be indicated in the fault codes
The ECM of the vehicle continually tunes the engine while running ( around 100 times a minute) and as long as all the sensors are within parameters ,the engine will remain in tune
any sensors that are failing will leave a fault code and just because the engine light is not on doesn't mean that there are no fault codes recorded
basically "good mechanics do not fix what isn't broken"
8/31/2015 4:29:10 AM •
2000 Ford...
•
Answered
on Aug 31, 2015
Not finding what you are looking for?