...crank) 2 wires. if obd2 scans shows its not bad it is not bad. (99% of time is not) IT IS IN 1 OF 3 PLACES.(4) FRONT OF CRANK SHAFT CENTER OF CENTER OR REAR (IN 2 WAYS) THE ANSWER IS ALWAYS IN THE ...
where is and how to change the cranck sensor on 2000 nissan frontier 3.3 4X4. Hello shalom570, The crank position sensor is on the rear left-hand side(drivers side) of the engine. See image below. To ...
...any spark after the cam and crank sensor,ECU and the distributor have been replaced. It’s fired up 3 times but died straight away due to no spark did you reprogram the New ECU to the Truck ? if not ...
...staring right turn key truck sound weak to start and battery and altnator are fine.It takes 2 or 3 trys for truck to start but starts fine after truck has been running for a long period of time. ...
Hello, MY 2005 Nisan frontier will not start. About 3 days ago, the battery light would stay on after the engine started...had the battery checked and it was fine...then serviced it yesterday but it ...
2005 nissan frontier. battery is no more than 3 2005 nissan frontier. battery is no more than 3 months old, but the truck was not used for 20 days and will not start. was in a garage but the outside ...
...cranks very good, it has spark but i think it is too weak, however when i am craking sometimes it sound like runs for 3 seconds and after dies.i thought that it was the fuel pump so , i change the ...
...the road. About 10 mins later I started losing power again and the truck was running on about 2-3 cylinders. then it just died. It would turn over and try to start. I could get it to run after ...
2000 nissan frontier 6cyl 3.3l will not start. pretty sure it is either the crankshaft position sensor or camshaft position sensor. since the truck wont start and I dont have an obd scanner I can't ...
804 questions posted
Usually answered in minutes!
408 Questions
305 Questions
268 Questions
263 Questions
209 Questions