1984 Chevrolet Camaro "shift cable" Questions

...at higher rpms, Will a fluid filter change stop that problem? No not likely. Is the 3-4 shift rough? What speed are you going when it shifts into 4th? It likely just needs the T.V. cable

...resets the shift point of the cable to factory specs. Interestingly enough, I could always tell when my son would hammer the throttle as I would have to go out and re-adjust the TVI cable as

...cable. If it's out of ajustment it can cause the hard shift. The transmission thinks the motor is going faster then what it is and will shift harder. Put the car up on jack stand in the rear and put ...

...shift cable in park only reaches to trams lever in 1 won't reach if lever in park or neutral makes no sense cause I know it use to work If the car starts in first, it sounds like you have a problem ...

...Have an 86 IROC Z with an automatic transmission. The engine is a 90 350. Have had problems with shifter cables (replaced 2 in 1 week, and needs another). Shifted fine yesterday, but not this ...

...cable: off idle crawl trans appears to shift, heavier gas, pull first to second no second - engine RPM stays same - go to third & third appears to engage. What's my problem? Maybe the shift valve ...

...shift linkage came loose at the tranny end. On the driverside of the tranny there is a cable hooked the side of the tranny. At the end of the cable there should be a slot that a bolt goes through and ...

...I try to put it in park, but car is still in drive! I can reverse just fine, but when I shift into park it still moves forward. What's going on?! Your shift cable has stretched.Replace

is stuck in drive,the shifter will shift,but it will stay in drive..... You need to check your shift linkage located on the side of your transmission where your shifter cable runs down and is attached

...shift after second gear or inany other gear and drives in park plus my cables are streached tv and shiftin cable would i need to rebuild Not completely sure but I had a similar problem on an older ...