1968 Camaro 454 TCI Comp Turbo 400 reverse manual - no second

SOURCE: no reverse sometimes geo metro a/t

The accelator cable is "Y" shaped. one side goes to the carb and the other to the tranmission. If you have the carb.side too tight it will give you the problem that you are having.
Robert

Marvin

• 85242 Answers
• Posted on Mar 11, 2009

SOURCE: car idles low, stalls after start

Common issue at the shop (i'm a ford technician), here is what I do to correct it.
Here is the most common cause of surges and stalls at stops and low erratic idle speed and rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

SOURCE: tourque specs for 1968 camaro

Do you mean the tightness of the ball joint nuts? If you do use 55lbs, then tighten further if cotter pin hole does not line up. DON'T back off to get pin to go in!

SOURCE: 87 chevy truck with TBI idles too fast

Spray the intake with carb cleaner to find the vacuum leak. Check where the EGR mounts and the throttle body gasket sense you had both off.

SOURCE: 2500 to 3000 rpm idle

Change your Thottle positioning Sensor. My 93 lesabre did the same thing and i changed the TPS and it stopped.