1998 GMC Jimmy "internal ac unit leaking" Questions

...ac blows but not seeming to blow hard thru the face vents, I took the floor vent piece alose and blows hard thru it. Also when switching from defrost to vents, it takes a minute to switch to vents. ...

...unit just blows hot air I adjust the temperature on the button setting but it just stays hot even when I turn the A/C on? Also, it runs good but if I really get on it it blows white smoke? Can you ...

AC compresor, Belt vibrating and slipping. Was told the compressor was going out or the bearing in the unit. $800.00 fix. Could it be anything else? Hi, if the serpentine belt on the pulley of the a/c

...ac outlet pipe blocked there are two common causes of water in the front footwell on ford focus. Before about 2008 they had a pollen filter located in the engine bay under the front windscreen which ...

ac on for them to turn on. Its now overheating and makin a noise. There is no water in the oil. WHat could be the problem? change your temp sensor if there is one bc i believe like my car it regulates

...AC voltage leak. which can affect the engine performance. There also could be another reason why your engine is dieing. Look at the maintenance history and see when the last complete tune-up was. The ...

...AC - transmission issues I just purchased a one-owner, used 1997 Jeep Cherokee Sport. It appears to be well maintained and a quick look-over by a reputable mechanic says the same, and aside from a ...

...AC on makes it worse.what can cause this? Rough idle in drive or reverse Idle Speech There are a lot of things that can contribute to an idle issue on your Honda. In fact, in the end it may still be ...

...ac compressor Service and Repair CAUTION: When the A/C compressor is inoperative due to internal causes, clean the refrigerant system to remove any debris or contaminants to prevent damage to the ...

...ac on and see if the front of your compresser spins or not. if it does clutch is good. but it could be that your compresser is still bad. either way i recomend you go for freon and start there. when ...