1990 Nissan Hardbody King Cab "light engine" Questions

...engine and the oil light stay on, but after 1 or 2 min the sound dissapear and the oil light goes off. and the car have a incisistant idle. I need your help I thought of replacing the engine. Car is ...

engine management light stays on - changed primary fuel filter and now it wont start run the fault codes to find which sensor/ servo made the light come on. Replace the faulty item and reset the light

...engine management light keeps flashing its like a ghost problem that comes and goes it could be distribitor or transponder and keycoding? check starter relay its blue on the right side in the engine ...

86 Nissan Hardbody lost power to all gages and all lights I have an 86 Nissan Hardbody. Lost power to all gages and all lights. Runs straight off of battery. I replaced Ignition switch, alternator and

engine light on? Any fault codes? Has a engine running self test been done? Well we kinda need a little more information. Is your check engine light on? Does the car run like it’s suppose to when u be

my 04 hardbody keeps cutting out wont start engine light flashing then next day it will be fine, untill the next time check the egr valve on it

...engine so it is at operating temp. Loosen the hold down bolt for the distributor (10mm) Hook a timing light to the #1 intake side wire. (the cap also should have "I1" on it.) hold the timing light so ...

...rd28t ohc 6cyl patrol y60 wagon.not all glow plugs heat up and motor runs very rough at start. glow light in dash flashers when motor has started. Glow plugs are all ok if only 3 plugs heat, ...

light on dash has gone out You may have lots of carbon soaking up the fuel so the glow plugs can't get enough fuel to heat up and fire. The crd adds more highly flammable for ignition. Ffuel pressure:

...the coil. Being an 89, you should get a check engine light if the sensor on the crank is not receiving a signal. Anything coil-distrubutor-spark plugs should not send a specific code. Hope this ...