1999 Mitsubishi Eclipse "intake manifold" Questions

intake manifold on my gs now it wont stay running i had to pull out my intake manifold on my 03 eclipse gs to repair a crack. i put it back together and now my brakes dont work and it has erratic rpms

INTAKE MANIFOLD. If you look closely, you'll see that the intake manifold is a two piece setup(Upper Intake, Lower Intake). You will need a new gasket after removing it. Don't be cheap either, get one

...intake manifold appears to be covering one of the screws needed to remove the old coil pack. Is there a special tool I need or a trick I need to know to remove the old coil packs without removing the ...

...intake plenum and the exhaust manifold. The posted numbers is the sequence of the disassembly and reverse when you are ready to put it back together. Torque values are also displayed. The exhaust ...

...intake manifold to get to the opposite three spark plugs. How do I go about doing this? just remove all the bolts and hoses atached to the upper intake or go to the autoparts and buy a book for this ...

...using stock 1g/2g parts would be: 6-bolt w/2g pistons. compression: 1g= 7.8:1 2g= 8.5:1 1g head/intake manifold 1g throttlebody 2g throttlebody elbow 2g exhaust manifold 2g o2 housing 1g 14b ...

...intake manifold stay. On all models, disconnect starter wiring connections. Remove starter mounting bolts, then the starter.Installation Before mounting starter, clean the mating surfaces of starter ...

...intake manifold to valve cove was not there instead they had the intake manifold outlet blocked so no air goes in or out. I decided to do it like my haynes manual says. Like the picture i inserted. ...

...Exhaust Gas Recirculation (EGR) valve, in order to modulate exhaust gas flow from the exhaust manifold into the intake manifold. i hope this helps you plz vote comment if need more help ...

...sensor located on a 2002 Mitsubishi Eclipse Spyder 2.4L? its by your intake manifold on the bottom of the engine block. there is a heat shield covering it which will need to be removed to get to ...