1998 Chevrolet Malibu "tools need remove front" Questions

Ad

...need (tools) and the process to replace front and rear brakes in a 1998 Chevy Malibu? Tools: 3/8 drive sockets and ratchet. 4, 6in extensions. 3/8 to 1/2 in adapter and 1/2 in breaker bar, SAE wrench ...

Ad

...need a large breaker bar, its torqued to about 100ft-lbs 5) Remove tie rod end with a tie rod/ball joint separator This can also be purchased at your local auto parts store. Some spindles are made ...

Ad

Question about Chevrolet Malibu

2 Answers

...remove door panel. KD does make a tool that will properly pry the door panel away from reainers. KD 3705 You might get by with a screwdriver. One other thing you may need to have the window down to ...

Question about Chevrolet Malibu

2 Answers

need to know where the main seal is on my Malibu, the oil light kept coming on at 500 RPM, when I hit the gas at 1000 RPM the light goes out, check the oil level 20 minutes after car is parked let the

need diagram how to install timing chain 2004 Malibu overhead cam Procedure is pasted below. Please let me know if you have questions. Removal & Installation2.2L Engine Before servicing the ...

Question about Chevrolet Malibu

1 Answer

...need any special tools? Or should I drive it to an auto shop. You will need a strut spring compressor. You can probably buy a cheap one for about as much as a shop would charge you to install a new ...

Question about Chevrolet Malibu

2 Answers

tools call around to your local auto parts store or tool rental places to see if they have a pressure tester. You can then pressurise your system with this tool and it should help you to find the leak

Question about Chevrolet Malibu

1 Answer

...need to remove my front door panel to replace a speaker. how do I remove the window crank? there a special tool to remove that clip or you can use a women nylon slip the nylon beetween the handle and ...

...tools are needed? Is it complex? I need detailed instructions. I can't afford 600.00$ right now if you are talking about the front wheel bearings they are pressed in and you need a floor press to ...

Question about Chevrolet Malibu

3 Answers

remove it, the transmission fluid should be level with the bottom of the hole. No special tool required. I agree it does seem stupid, but the reality is there is no dipstick.I wish I could explain the

Not finding what you are looking for?
1998 Chevrolet Malibu Logo

1,551 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...