...bolt it is without taking it apart? the flywheel is located behind the engine, inside of the bell housing and is not visible. it is bolted onto the crank shaft by several bolts ( 5/8 or 9/16ths if I ...
How do you change a flywheel on a 1998 Ford Expedition, 5.4 L Eddie Bauer edition?? You will need to remove the transmission and (transfer case )if equipped to gain access to the flywheel. Once the ...
...FLYWHEEL THER IS TWO DOWEL PIN ONE PER SIDE TOWADS THE TOP OF THE TRANSMISION PART OF ENGINE BLOCK THEY OFTEN BIT AND HOLD ON GOOD IF YOU ARE SURE THAT ALL THE BOLTS OF THE TRANSMISION ARE UNDONE YOU ...
Question about Ford Expedition
...the trans fluid still the same bad torque converter perhaps did someone forget to bolt it fast to ...
...are tutorials Check to see if your car needs shems in starter bolts, if starter is too close to flywheel it can cause it to hang up and stay ...
...flywheel the bolt's are not tight..Now if you hear the knock and it's high pitch metallic then chance's are it's a rod or lifter in the engine.If the noise is a thumping dull noise you have a bad ...
...its end part, called a "Bendix Drive" working. The Bendix drive is the gear that goes against the flywheel to spin the engine when you turn the key to START. It is possibly the Starter bolts are ...
...bolt or screwdriver in flywheel with starter removed.If lights do not dim check for open circuit in starter or cable.Sometimes a few sharp raps on the starter body will get it to work ...
...bolt the flywheel to the crankshaft, I don't know if these new bolts are stretch bolts or not, the supplier of the new single mass flywheel couldn't tell me if they were stretch type bolts or not and ...
...flywheel with right bolt pattern the motor is a amc 360 but a flywheel from a 360 has a differnt bolt pattern than mine any help please are you sure you have an amc 360 and not a 304 and also are you ...
1,903 questions posted
Usually answered in minutes!
2,188 Questions
1,825 Questions
1,627 Questions
1,696 Questions
1,048 Questions