2002 Nissan Xterra "crank position sensor 02" Questions

what the sensors do they detect faults with temps,knocks,emissions, timing,crank position, fuel air mix,throttle position. so the 02 is detecting something and that something is what needs to be found

...po134 02 sensor but that wont cause it not to start,It cranks but wont start has plugs,wires,coil pack,fuel filter and crankshaft position sensor Here's a link to Code P0134. P0134 OBD II Trouble ...

...crank shaft sensor and 02 oxygen sensor bank 1 sensor 1 and bank 1 sensor 2 but they keep showing the same codes P0016 Crankshaft Position - Camshaft Position Correlation P0135 O2 Sensor Heater ...

02 1500 4.7. Had the timing chain replaced. Now it cranks but wont stay running. Thoughts? check the circuit for the crank position sensor or cam shaft sensors

...not start. no power to injectors Take a look at your cam position sensor and your crank position sensor. if those are good then you may want to do an exhaust system test to include your 02

...crank sensor pigtail Yahoo runs but only for about 2 minutes and then it just turns off sure the wire was broken I spaced a new one in and when it runs it runs fine but it just shut off at about a ...

...Crank Position Sensor (NE Signal). 03 Cam Position Sensor (SGC Signal). 05 Knock Sensor. 08 Air Flow Sensor. 09 Engine Coolant Temperature Sensor. 10 Intake Air Temp. Sensor (Air Flow Sensor). 12 ...

position. It may be located in a similar location on your 05 Ex. I do not know where the crank sensor is located. I hope this helps. cam sensor bottom of engine p.s. before you replace part ford has a

...go out as you crank the engine? If not, if it stays on, the computer isn't getting a good crankshaft position sensor signal. Replace the sensor or fix the wiring harness. Bad sensor is fairly ...

...CRANK WELL IN MORNINGS BUT AS SOON AS IT WARMS UP IT SEEMS TO RUN FINE. did you replace both 02 sensors? 02 sensors and camshaft position sensor do most of the engine timing. A bad vacuum hose will ...