2007 Chevrolet Cobalt Coupe "replace brake switch 2006 chevy" Questions

brake pedal - it's a relay your hearing. I had a similar issue and found out one of the door switches went bad and was shorting out. The one that went bad was my front passenger side and located it by

...brake lights on a 2006 Chevy Cobalt sedan {: ) The stop lamp switch controls the on/off function of the stop lamps including the center high-mounted stop lamp( CHMSL). The stop lamp switch get its ...

brake pedal is pressed in, and won't allow the ignition to be turned fully off if the car is not in park. To remove my key I used to shift from Park to Drive repeatedly attempting to get the switch to

...Replace plastic panel. Sometimes the ignition key can be jammed in the ignition by the steering wheel lock. If this is the case you can free the key and release the steering wheel lock by turning the ...

Replace the slide indicator and guides in the shifter following the procedure below: Apply the parking brake. Remove the upper console trim. Refer to Trim Plate Replacement-Console Front in SI. Remove

...brake light switch but the problem still persist. the third brake light still works the flashers and turn signals blink very fast Sounds like a bad turn signal switch. I bet if you wiggle the turn ...

brake light switch. Still not working. Any ideas. When I turn my blinker on to change lanes my Cruise Control will disengage. There are some ideas in the link, but because of the Cruise Control issue,

...on my 2006 chevy silverado but the third brake light does. I replace the turn signal switch and checked all fuse's, relays and the brake light switch. may be it is unpluged in the back under the ...

...on dash flash quickly when engaged. Both front blinkers work correctly. Both rear blinkers do not flash when engaged but actually appear to be stuck on. Your brake light switch is faulty,replace

...replace brak switch, next if that doesnt work check the brake light to see if they work if not or if so check all fuses even under the hood fuse box, hope this helps. here a picture of the shift ...