Dayton Gas Furnace Heater "blinking 4 times" Questions

4 BLINKS AFTER 4 MINS OF RUN TIME Change the filter. I believe 4 blinks is for a failure on the high limit switch.

...blinking led light that blinks 4 times and my furnace will not light. What could be the problem? Gas furnace fault or error codes for common furnaces - Gray ... ...

...blinking and the current room temperture will appear after desired temp. is set.4 the heat will turn off shortly after the desiredtemp. is reached and the temp. ndisplay will blink.5 the heater will ...

4, of a few times blinks 3 and stay off, HSI does not glow, but i smell some gas. 3 blinks is for high limit. I have tested all limits and rolls and all are good, I have shorted the presure sensor and

4 times If you look at the wiring diagram in your furnace you will see that 4 blinks means there is either a blockage of air or your room air blower is not working. Check the air filter for any debris

i read what to do about 4 blinks and i got the heat back on but it has stopped again ...it has stopped and restartd.why d seval times What was the code for four blinks?

...4 furnace. The light on the board blinks 3 times. The furnace won't light at all. What could be the problem? Hi 3 blinks should mean it is the pressure switch there should be a code in the manual or ...

...4 times any suggestions? I think 4 blinks is the code open pressure switch, check inside your blower door to verify. The pressure switch is a round metal part with an orange hose going to it. If you ...

...4 days and turned off the power - now the electric ignition will not fire, and the 3 lights are blinking. Is it likely the wiring, or the furnace? Power is there, or no lights would blink. Steady ...

...4 No heat. when I push the button the status light blinks 3 times. The blower runs. What do the 3 blinks mean? Since most units do not have the same diagnosis,remove both cover panels and read ...