Sherwood RX-4109 "goes stand mode" Questions

...goes to stand by mode just playing for 3 second ... rest every thing is ok I just hear a click sound (relay switch off) and it goes to stand by mode again switch it on .... same thing again it play ...

...goes into stand by. It use to only happen if say speaker wires were touching but not now. Please Help. same here ,men , i start the tearing apart hehehe, and i think it can be one the little chip ...

...goes into stand by mode. Press stand by mode button nothing happens , how to fix? Hi Joanne, the unit would have to be serviced, please follow this link to locate an authorized service center in your ...

...goes to stand by when turned on. All components and speakers disconnected and still goes to stand by. Any suggestions? This is most likely a "protect" mode. A problem has been detected and the unit ...

...goes straight to protection mode When I press the stand-by button to turn the unit on it turns on then as soon as you hear the speakers click in it goes into protection mode. This is even with ...

...cycle power if the power stays on reconnect equipment one at a time cycling power after each peice reconnected. If the power goes back to stand by with nothing connected the reciever needs ...

stand-by mode instantly. This is an Onkyo TX-SR500 This indicates that the system is going into protect mode. First disconnect all speaker wires (with the power cable disconnected). Then turn the unit

...goes to stand by mode It goes to standby mode moment it is switched on. Tried after removing speaker wires but same thing. It has a blown channel, unless you are good at repairing them I suggest an ...

...then it goes off to stand by mode. i have reset the micro process and no use. pl any one can help to solve this problem. Maybe the audio amplifier IC´s are damaged that´s why go on the protection ...

My receiver is shorting out and goes to stand by mode units going into protection due to fault in unit or speakers