WATER WON'T GO INTO WASHER, WHEN I SWITCH WATER LEVEL SWITCH BACK AND FORTH IT STARTS GOING IN. IS THIS A BAD WATER LEVEL SWITCH. Yes, this sounds like a water level switch to me. Sorry I can't ...
washer off if water still keeps filling you have a bad water valve,do the same test on hot,if both turn off when you push stop then check the water level hose from the water level switch to the tub,if
...washer. 1. Water level is too high during wash cycle. 2. Sometimes no water during rinse cycle. 3. Other times, too much water during rinse cycle causing overflow during spin cycle. It's overfilling ...
water supply hoses connect to the washer (both hot and cold) were clogged with debris--thus reducing the water pressure in the machine. Good water pressure is needed to "flush out" the detergent, etc.
...is working as designed. on kenmore washer remove or find water level sensor and adjust the level control with phillip headed screw turn clockwise raises water by about two inches in a top load ...
...Washer Water Level Switch (part #W10337780) - How To ... ? 7:16 https://www.youtube.com/watch?v=oi8uUPFgxbI Aug 23, 2011 - Uploaded by AppliancePartsPros Buy the new Water Level Switch W10337780 ... ...
...Water When filling the washer machine, the washer machine keeps filling until it overflows. Do i need to replace a pressure sensor or some kind of water meeter so that the washer machine "clicks" and ...
water level on top of the washer; make sure it is in the center. Take a look at the level and see where the bubble is in the water level? Accordingly you have to lower or raise either 4 corners of the
...washer wont aloud my water to go insidethe washer If the washer makes a humming sound, but no water goes in, and there is no other action, the water shut-off valve is off (outside the washer), or the ...
655 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions