Maytag Neptune MAH5500B Front Load Washer "not spinning water clothes" Questions

Cloths still very wet after final spin cycle Spin cycle does not get enough water out of the cloths in the wash load Use spin ccyle again for proper operation and to help remove water.

...water from the clothes. If washer hums when it should spin, and the washer will not drain, you may have 2 issues. First check that the drain pump, drain hose, and wall drain are free of debris. The ...

...if the machine is not spinning all of the water out and your clothes come out sopping wet....read the long thread I typed out to another person earlier.....it's about 2-3 questions up on the same ...

...spinning okay and the clothes are still wet, then I would look at the water inlet valve. Check to make sure that the solenoids are good at the water inlet valve. They can be checked for continuity ...

...clothes? If the water is draining out o.k. then either there is no signal from the water level pressure switch, no signal from the control board or a problem with the Spin windings. I have a neighbor ...

...spinning to spin-dry clothes. My Maytag Neptune Washer will pump out the water, but not go into the spin cycle to spin out the major part of the water from the garments. What might be wrong? first ...

...is still water in the tub. Put the machine on "Spin" and cheat the lid switch into thinking that the lid is closed. Use a clothes peg or wide ended screwdriver and see if there really is a

...spins the water out of the washed clothes. A pump is connected to the bottom of the outside drum. If the pump fails, the water would not get pumped to the drain and would collect in the outside

...out and will correct the problem ; if there is no water in the machine when you complete the cycle but the clothes are wet it did not spin more than likely your door switch is probably bad replace ...

...Water can be rung out of clothes at these times. Hello there: The clothes are wet after spinning or at the end of the cycle please try each one of these solutions that i have provided below Motor ...