Maytag Neptune MDG9700A Gas Dryer "remove cover rear sliding door" Questions

cover plate...remove 2 screws to see the drum shaft ...remove the snap ring to remove the 2metal washers..and 1 fiber washer ..their should be a fiber sleave/bearing that slides onto the shaft that is

...Remove the top cover by removing the two 10-mm screws attaching it to the rear of the dryer then slide the cover rearward and lift it off the dryer cabinet. Take note of the notch in the top cover ...

...remove screws under cover, pull top forward and lift. it hinges in rear. remove 2 screws on front holding front panel to cabinet sides. disco door sw and lift front panel up to remove. undo belt from ...

...Remove the cover over the drum bearing and earth strap (2 screws) 6: Remove the cover over the fan assembly (numerous screws) Step 4 7: Remove the earthing bracket (copper assembly held by 2 small ...

...cover off the dryer cabinet. Remove the screws securing the heater PCB board and disconnect the black and white wiring harness connectors from the board. Remove the four screws attaching the console ...

...Remove 2 screws under lint filter cover, grasp lid near the front - pull toward you and up - top should hinge up out of your way. Reach in and unplug the door switch harness Remove 2 screws found at ...

...cover carefully. (5) After you have the lid open have someone hold it it up or prop it open. Using a 5/16 nut driver remove the two screws (one on each side) and insert the pointy tip of the spatula ...

...Remove 2 screws at rear top which go through the brackets holding the top panel, slide back the top panel a little and lift it off. 2. Pull off the rotary timer knob and remove 2 screws beneath. 3. ...

...Remove Top Cover and Front Panel, Top Cover / Door Switch / Front Panel /Gasket Removal? 1. Disconnect power supply to unit. 2. Use a plastic putty knife to depress the locking clip between the Top ...

...COVER. ALSO WHERE YOUR LINT FILTER GOES IN AT THERE WILL BE 2 SCREWS UNDER THAT LID TAKE THEM OUT AND PRY THE TOP UP AT THE EDGES ON THE FRONT BETWEEN THE TOP AND FRONT PANELS. THEN REMOVING THE DOOR ...