Frigidaire ATF6000ES Front Load Washer "ring timer" Questions

...ring I can move it manually. Is the complete timer bad? your white outer switch is stripped. i just had GE send me my 3rd one and it isnt 2 yrs old.( in april it will be). that is why you can move it ...

ring (Dial & Guard Timer - part 387997) on my Kenmore washer spin freely without turning the part that controls the actual cycle. Must use fingertips to grasp and rotate the bottom-most ring (possibly

...timer. The timeer can be turned using the ring behind the knob and will then operate normally. I can not set the timer on my GE washer. The knob just turns with out stopping. Usually, if you pull the ...

...ring on it, the timer is in 4 pieces. Pull the top middle part out. Then there's a white locking piece in the center. Once that's out the other 2 pieces will pull out. Note: The photo shows the top ...

...off. The contol time seems to be working OK if you use the ring behind the know to turn the shaft. The shaft go'es all the way thru the timer on most and you can keep it from spinning there. ...

runs and stop after about 3 minutes put the clothes in, run for about 3-5 minutes, bell rings stop Sounds like a timer. Your timer is sticking

...ring back in the same spot so you won't mess up your timer settings. Now on the back of the washer, there are 4 screws. 2 at top and 2 at bottom on the silver panel, remove them and that should free ...

...the cloths are very damp, you have to ring them out by hand Hi. this is a failed timer device. simply replacing the timer control module will eliminate these issues you are having. thank u rate ...

...UO-43501) ? Where can I find a Washer Timer M520 (Inglis Liberator Plus - model UO-43501) ? Two rings on the cartridge are a bit worn and I've "fixed" it by bending the contacts to ...

...Timer dial knob spins freely. Have to set wash preferences by turning inside ring by hand. How to fix? probably new timer part inside timer that locks shaft when pushed inis not grabbing and ...