...cover off relay...clean plugs and pins( from oxide)...if it starts hard get a har d start kit for compressor what is a hard start kit for this Danby DWC512BLS and where do I get
Unit stopped cooling and compressor is hot. Try a "3-n-1" Start kit
...thermo stat works, but that's it. compressor is tripping overload try a hard start kit, probably bad ...
...be available. The electronic stat used 2001 to 2007/8 is still available as well as an upgrade kit to replace the old style. You can call the factory at 800-223-3900 and ask for customer
...sure they put all 3 new peices in, thermistor, potentiometer, and contol box. all 3 come in one kit, 20 min to ...
...disruption) as the pressure in the high and low side takes a little while to equalize. A hard start kit could be installed which adds a capacitor to the starting circuit of the compressor might help ...
...drill and mount in the cabnet closer to the controller. It looks like they also supplied a retrofit kit 2767-s is the correct thermostat for this. The only thing you will need to do is drillout the ...
...number (to identify which control it uses) and you can buy the part direct from them. The control kit is about $150.00, the old style thermostat about $100,00 and if it is just the thermsistor,
...control. I have replaced the potentiomenter, the thermister, and the control block all were in a kit but the problem remains. Any additional advice appreciated. If after adjusting your thermostat ...
...near the bottom center of the evaporator plate (out of site). The factory sells a replacement kit with a much better fan and new power supply. You can reach them at 800-223-3900. Good-luck. Hi, ...
202 questions posted
Usually answered in minutes!
33 Questions
1 Questions