...oil....which on GE washers often gets dumped onto the floor.Remove power, tilt the washer back and check on/around/near the large center pulley under the tranny....often the belt and pulley throw the ...
...power is connected. Is there some sort of shutoff switch or sensor I should be aware of? Oil is no problem. The door switch/interlock is faulty. Replace door interlock. Try closing the door firmly ...
Question about Maytag Washing Machines
...power point before you conduct these checks. Is the water clean, dirty or oil contaminated. if you can't determine exactly where the leak is coming from try placing a chux cloth around a hose with a ...
Question about Washing Machines
...oil like substance is coming through some of the small holes in the side of the tub Hi, From your description, it sounds like you have a leak in the washing machine's transmission. The most common ...
Question about Fisher and Paykel Washing Machines
...oil . a picture is worth a thousand words or possibly fault 2, your machine is dirty by using washing powders, always use liquid washing detergents like Cold Power or simliar - they are
...oil leak can cause the transmission to seize up. If you notice rust accumulated on the transmission assembly, you probably have a bad seal. Water could have gotten in there causing it to fail. A ...
...oil on floor under washer. what's my problem/ This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump removes most of the water) ...
power. for the last few weeks all the light colour clothes i wash get like a oil stain and it doesn't come off. i've washed the inside of the machine and rinsed it out but it still continues. is there
Question about Kenmore Washing Machines
...oil on the floor. what could my problem be? This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump removes most of the water) ...
...power and hoses, remove the pump (two clips), the motor (two screws hold two clips on the motor), lift and set the motor aside. Remove two 1/2 inch bolts for the motor mounting plate and three 1/2 ...
1,828 questions posted
Usually answered in minutes!
200 Questions
88 Questions
87 Questions
45 Questions
22 Questions