Hotpoint Aquarius WF000 Front Load Washer "pressure runs 15 minutes" Questions

...15 minutes for a load to start Hi, LF means that it is taking too long to fill. (If the water fill time exceeds ten minutes, the water valves are turned off and LF is flashed.) Supply hoses could be ...

runs but seems to pause more and take longer to complete a load of clothes. Sometimes they spin out and sometimes they are wetter. 5d means you're using too much detergent. SH: Open thermistor. Unplug

...15 minutes, and then I was able to run the spin & rinse cycle. Ok, that's a different scenario. Generally, when a washer is agitating and develops an overload that stalls or overheats the motor, the ...

Pressure SW. See page 8. - Check the resistance of the motor pump. See page 8. - Plug in washer or reconnect power. - Run the drain cycle. - If the failure continues, unplug washer or disconnect power

...15 minutes into the cycle. The little tube from the drain pump is clogged, but I cleaned the drain pump filter. The washer worked for a couple of days, then reverted back to the old problem. If i ...

...15 months. We were away for about 3 weeks, and since we have returned, I put in a load of clothes, and it tries to start washing, but then SUD followed by F35 appears on the screen, and it makes a ...

runs fine until it reaches the 35 minute mark and the E70 error starts again. Is this a mechanical problem, the hookup, or the water pressure? Thanks. May 15, 2009 Hello, I had this exact same problem

...15 Motor Control Unit (MCU) Error If the MCU detects multiple resets or errors during a wash cycle it will go into this error mode. Potential Causes • Check Wire Harness connections to the MCU, the ...

15 seconds - no luck . i tried pressing the end of cycle sugnal button 5 seconds..no luck..any suggestions? Inspect the water level pressure switch tube, run diagnostic cycle, and see if there are any

...pressure tap to flush hose forward and reverse until water runs clear. If you live in a very cold climate maybe the hose is iced up inside. Also check all filters to see they are not blocked up. Hope ...