HP Pavilion A610n (PC106A#ABA) PC Desktop "remove plastic panel" Questions

...the plastic, helps soften the plastic of the Power On button, enough to remove the PS_ON switch more easily. This Power On switch should be a good replacement, ...

...plastic is soft enough to remove the power on switch. The switch itself is held in by plastic tabs of the Power On button. You can also dip the unit into real warm water to soften the plastic. (The ...

...remove the front panel, press against the plastic tabs carefully slide it out, {this step may not be required} locate the optical drive and remove the screws, {2 to 4 per side} next remove the two ...

...power button removal ok take off both side panels at the front inside you will see 3 plastic lugs on each side push them to release the front panel there you have access to the the power

...Remove the front panel, locate the plastic retainer on the rear of the button, sometimes it will break/stick, free the obstruction, clean area of dust, lightly apply some silicon spray. Here are some ...

remove that left side panel. (Actually the Right. Viewing a computer from the Front is the correct orientation, when referring to the Right, and Left sides of a computer) Viewing inside your computer,

...remove the screws and slide the drive out.If the drive is retained by a plastic latching system, lift the latch to slide the drive out.Set the old drive aside. If the drive is to be re-used, place it ...

...remove the side panel from the desktop so you can see the motherboard, you will see a battery like this >>. Near to the battery you will see a plastic "jumper" this will reset the cmos if you move it ...

...plastic cover. In addition should it be a Dell it could have buttons on the sides, top & bottom, or a lever AND screw on the rear of it's left side. Carefully inspect your case. If there are no ...

...plastic housing, of the Power On Button assembly. You have to remove the Front Panel, to access it. HP Support main page above > How To > Adding/Replacing hardware > Removing the Front Cover ...