...paper tray, take out the paper, look to see if anything clearly amiss with either the printer or the paper tray itself, reflll the paper tray with a moderate quantity of preferably fresh paper - ...
company &model no. Brother MFC-8860DN paper jam fixed: 1. Paper in tray wedged to front of tray, binding up/down flip action. 2. Move back the tray position guide in the rear of the tray for more room
Paper tray won't go back in I have a HP 3310 and the darn paper tray wont go back in, it will if I force it. The paper pick-up seames to be hanig low. Any one know how to get to it? go to the back of ...
Question about HP Office Equipment & Supplies
...paper tray, now paper wont feed thru. Back paper tray came off my rx 500, I then found a 2" spring just sitting in that paper feed area? Dont know where to re fit it, can you help? You must open case ...
...paper tray and so the paper led light wont stop flashing. There is full toner and a new drum. I have tried holding down the 'go' button with the cover open to reset all the led lights but it hasnt ...
...paper jam, these printers are bad about doing this when you let the paper run out. Now unplug printer an let it sit for about an hours or so an shut down computer once you plug back up an ...
Question about HP Office Equipment & Supplies
...paper in tray glossy side down as per instructions. Printer spits seet out unprinted and says paper loaded upside down. I turn paper over with glossy side up and printer will print but it is on the ...
Question about Dell Office Equipment & Supplies
...paper to the correct tray. Now this tray is going to have a switch located toward the feeder that tells the printer paper is loaded make sure the paper is back far enough but not to the point where ...
...wipe the rubber rolloers with a moisten piece of cloth, to get back its picking ability reinsert tray, make sure paper inside is shiny side up reinsert power cable try to print hope it works, good ...
...paper tray. Push the paper guides until they are tight against the paper on all sides. If the paper guides are loose or not properly adjusted, the printer may not sense that the paper is in place. ...
77 questions posted
Usually answered in minutes!
2,817 Questions
2,162 Questions
1,869 Questions
1,584 Questions
1,504 Questions