Question about Harman Kardon Audio Players & Recorders
...sec. after i turn it on. I should tell tou a little more about the original problem. It had been humming louder and louder over the last few months and video also had some rolling noise. I opened it ...
Question about Marantz Audio Players & Recorders
amp problem.Try pushing and holding down these 3 buttons s.speaker b and att and exit buttons for at least 3 sec or more.should reset.If not also try pushing and holding down mult speaker and exit and
...sec, and then the stanby light blinks, What do you think? This is the thermal overload for the amplifier section. unplug unit and check all speaker connections for a crossed wire. After all ...
...turns OFF it self after 10-30 sec. Test: - Detach 5pin cable which going from AMP Bar Code to HDMi PCB (Board) -Turn ON the power of unit If Unit will power UP and doesn't turn OFF. Solution: More ...
...sec. Then the power light would turn red and shut down. I took it to The Sound Company in San Diego where I had purchased my complete system. They sent it to California Audio also in San Diego ...
sec. and then the unit switches off again (rigt after the second relay-click). I think I have Isolated the root cause to be in the display-board, as I still have the issue if the only connected boards
Question about Kenwood Audio Players & Recorders
...sec. then shuts back down Overloads can be from excessive periods of high output and shorts would be wiring issues or a speaker blowing up. You should be able to feel if it's hot. WHY is it ...
...receiver shuts off after 3 secs even before sound is heard what should i do Generally speaking, an amp protects itself from heat, shorts, overloads and operator exuberance by refusing to turn on or ...
...sec it shut off with a poping noise through the speakers. Then the led was blinking. I did not notice if it was doing it before so I assume it wasn't. any ideas? HelloThe power amplifier section of ...
sec., then shuts down. What's the diagnosis? check ur speaker wires, try disconnect all wires from back of unit and then try to turn on unit . if it stays on whit no wires attached than u have
32 questions posted
Usually answered in minutes!
43 Questions
37 Questions
45 Questions
19 Questions
14 Questions