...lamp,cover` and I cannot do anything with the projector. When you open the lamp cover for replacement of lamp there is a switch in the projector is OFF If lamp cover not fix proper after replacement ...
lamp/cover light flashes Did you replaced lamp in projector? if yes, please make sure lamp cover is fixed properly on its position. There is safety switch under lamp cover that needs to be pressed to ...
...lamp/cover. Hi, Either lamp is dead/ broken in projector or lamp cover is not fixed properly (its located at bottom side) Please check lamp and replace it if its broken and make sure lamp cover is ...
lamp cover. 3. after that remove 2 screws of the lamp and pull out lamp by grasping the handle. 4. replace the lamp with a new one and tighten the 2 screw s back in to position make sure that the lamp
Question about Sony Office Equipment & Supplies
Lamp /Cover LED and Power ON/Standby LED flashes. Sony VPL-EX1 turns on for a few minutes and then the Lamp /Cover LED and Power ON/Standby LED flashes. I have cleaned the air filter and also reseated
...lamp cover is not properly closed. Disconnect the mains power and carefully open the lamp cover, reseat the lamp and close the lamp cover taking care not to force it. A fault of this type would be ...
Question about Sony Office Equipment & Supplies
Lamp cover light flashes even with new lamp The projector will not turn on as the lamp/cover light is flashing. I have replaced the bulb and the lamp cover and air filter cover are both closed ...
...lamp cover and the air filter cover of the projector body if the projector does not power on. Ensure that the power cable is firmly connected to the projector and an active power plug. If the ...
...lamp cover by pushing two grooves lightly with the flathead screwdriver. You can see the lamp cover on the top of the projector. ( left side of the lens) 2.Loosen the two screws securing the lamp ...
2 questions posted
Usually answered in minutes!
75 Questions
41 Questions
39 Questions
27 Questions
39 Questions