Question about Optoma Office Equipment & Supplies
...screwdriver to remove the screw from the cover. Push up and remove the cover. Remove the 2 screws from the lamp module. Pull out the lamp module. Replace the lamp module in reverse the previous
...the screw. Remover the door. Undo the screws then holding the lamp module in place. Pull the lamp module out. Fitting the new lamp is the reverse process. Don't touch the lamp glass with bare
...the screw from the cover. (1) Push up and remove the cover. (2) Remove the 2 screws from the lamp module. (3) Pull out the lamp module. (4) To Replace the lamp module, reverse the previous
...lamp module in the DC socket. You'll notice there are two parts to the socket that mates with the lamp module before you plug it in, the top part with the larger receptacles carries the DC power ...
...lamp module. WARNINGS: ? To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp. ? Unplug the power cord before replacing the lamp. ? Do not drop the lamp ...
...bulb greww dim then replacement bulb was also dim The ballast module is bad. It controls the lamp. Don't throw away the original lamp. Once the ballast module is replace you'll have 2 good
...lamp module Failed to start after replace a new lamp module in optoma projector dlp in ds309 2 red light flash be sure to reset the lamp hrs, always a good idea to reflash with current flashware ...
lamp it self does not come on. if the lamp warning light is flashing, this indicates a defective ballast (lamp power module). if the lamp warning light is lit steadily, then the lamp would be at fault
lamp issues I changed the bulb and the power comes on but the lamp light flashes green what could the problem be Look at the ballast module. It controls the lamp operation
96 questions posted
Usually answered in minutes!
41 Questions
39 Questions
27 Questions
39 Questions
25 Questions