...fix this problem? You may have touching speaker leads going into the amp. Make sure the tinsel is not touching across the speaker inputs on the amp. Also check your ground. It should be solidly ...
Question about JBL Car Audio & Video
...fix the problem or do i have to tear into and repair the amp? check the ohm load on your speakers, you might have to low of an ohm and the amp is going into overcurrent protection mode, with the amp ...
...speaker wiring terminals, very possibly you had everything working for a bit, and one day the speakers may have hit to hard and the internal wire might have come lose. it;s very common problem and a ...
...speaker output terminals off, if there an easy way to fix that? are they soldered right to the board or can they simply be taken off and replaced? THAT USEUALLY MEANS UR AMP IS WAY 2 POWERFUL FOR UR ...
...terminal. Front channel had RCA's already connected to the receiver. Now the amp powers on, but the front channel doesn't work at all, and the rear channel is terribly distorted. - What exactly ...
Question about MTX Car Audio & Video
...car again its red and works fine till i turn them up again. How do i fix this. low Ohm speaker configuration or bad current intake. how many speakers you have on it? what size of power cables you
...speaker wires came out of the terminal and i think touched the outside of the amp. now when i turn the amp on even without the speakers hooked to it it goes into protection mode.just wondering if its ...
...speaker outputs are not working board is burned on the ground side right behind the terminal you probably burned a trace in the event and unless u have the right equipment and tools you probably wont ...
...fix this? Disconnect all speakers (at the amp terminals) and the RCA's leaving just power, ground, and remote connected. Does it turn on now without going to protection? If so, plug in the RCA's. ...
28 questions posted
Usually answered in minutes!
82 Questions
42 Questions
26 Questions
17 Questions
13 Questions