Kenmore 3.2 cu. Super Capacity Plus Top Load Washer "check claw machine" Questions

...check the installation of the coupler again. It's possible that if thew coupler wasn't fully seated on the motor or gearcase shafts, it is being torn apart by the motor. See the following: ...

...check it. It's a relatively inexpensive piece and is designed as a fail safe between the motor and transmission. It's very easy to replace if necessary. ...

...check and possibly replace? This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump removes most of the water) machine. First, see ...

...machine drains. If the motor coupler is broken, or worn, the motor may not be able to send full power to the transmission for agitating or spinning. See the following for how to remove the cabinet, ...

...check the coupler on 80 series Kenmore washer also washer motor hums but wont do anything else This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't ...

...check. Kenmore / Whirlpool top load, direct drive washers use a "Motor Coupler" between the motor and transmission. It's used as a fail safe device and consists of three parts. Two of the parts are ...

...check is the Motor Coupler. Kenmore / Whirlpool top load, direct drive washers use a "Motor Coupler" between the motor and transmission. It's used as a fail safe device and consists of three parts. ...

...check the motor coupler, a common cause for the drum not spinning. I ASSUME THAT IT WILL NOT AGITATE EITHER: See the following: ...

...check the clutch for wear or broken springs. Sears has a "rebuild kit" for the clutch if it is damaged. If the coupler looks damaged, it's a relatively easy fix. Pry the plastic pieces from the motor ...

...claw hammer but I've found that using a small (6 inch) pry bar works well. Carefully fit the plastic pieces over the motor and transmission shafts and press them in place (Use a 1/2" of larger socket ...