...Please check the fuse to this unit and also if the relay engages the power to the magnetron. If not check the relay drive and replace the drive transistor if faulty. Credit if the advice
...Power to element relay disabled in cook mode Replace the clock/relay board F-7 Shorted touch pad key sensed for 32 secs. Replace the touch pad/control panel F-8 Shorted meat probe Replace the probe ...
Question about GE SpaceMaker Microwave Ovens
...door switch, or a weak fuse holder. If it is a door switch problem, both the bad switch and the monitor/short switch should be replaced. On inverter ovens, the power relay should be
relay works also good , the power block 220 to dS 24 is good , the power coming too control Bord from there , but nothing goes out from control board the part, (i find only one part it is very hot -PE
...power from that MW relay on the control board, you must trace the wiring back to see if the proper voltage is going through your switches, any thermostats, and arriving at your control board. Your ...
...power relay..... Q - The microwave display counts down and the inside light is on, but nothing is heating and the fan is not running. A - This most commonly is a bad door switch, other possible ...
Question about GE SpaceMaker Microwave Ovens
...power from that MW relay on the control board, you must trace the wiring back to see if the proper voltage is going through your switches, any thermostats, and arriving at your control board. Your ...
...power relay board. These would come completely dis-connected after arcing and burning away the solder. Could be 1 month, could be years, but they knew it would happen. This power relay board feeds ...
Question about GE SpaceMaker Microwave Ovens
...power cord and check for voltage at the outlet. Also inspect for damage, shorts, or burn marks that can be a possible safety hazard. Bad door switchIf your microwave does not work at all and you know ...
...turned off and dis-connected. It can cause you to hurt yourself I suspect the power relay board. Cold solder joints that feeds 120volts to the HV Transformer. Well known failure with GE
4,203 questions posted
Usually answered in minutes!
257 Questions
57 Questions
46 Questions
27 Questions
23 Questions